
Airworks will exhibit at MACS 2023 Trade Show
September 6, 2022
MACS is happy to welcome Airworks as a return exhibitor to MACS Training Event and Trade Show . The big event will take place February 2-4, 2023, at the Gaylord Opryland Resort and Convention Center in Nashville, TN. The Trade Show will be on Friday, February 3 from 10:30am-4pmRead Article >

MACS Welcomes FutureTech
August 31, 2022
FutureTech has been an active member and supporter of MACS since 2017 and we once again welcome them to the MACS Trade Show as an exhibitor.Read Article >

An expansion valve myth explored
July 26, 2022
I have encountered many tech calls where a technician had replaced an expansion valve because of a problem with an evaporator freezing up and was frustrated because that did not fix the problem.Read Article >

Improving A/C cool down time
July 19, 2022
If there is an issue with an A/C system, then obviously that needs to be fixed and that will aid in cool down time. However, if a system is working properly and a customer is complaining, then the focus needs to shift toward educating the customer on steps they can take to improve cool down time.Read Article >

Diagnosing Faults on Modern Motor Vehicles
July 8, 2022
Motor vehicles have become increasingly more complex over the last two decades to meet the ever-tightening emissions regulations and increased fuel economy requirements, as well as passenger comfort and safety. This added complexity means technicians are flooded with additional data when diagnosing faults on vehicles. Below is a table outlining the difference between a modern vehicle and a vehicle from 20 years ago. This is only a high-level example to illustrate the differencesRead Article >

It isn’t blowing cold enough
June 29, 2022
"It isn't blowing cold enough.” Most any auto repair shop that does A/C work will often hear customers say this phrase. It can be the result of any number of things that can be wrong with an A/C system. Often it is a case of common things such as, a low refrigerant charge, a refrigerant overcharge, contaminated refrigerant, a blend door issue, a cooling fan problem, or maybe a weak compressor.Read Article >

The importance of A/C system oil balancing
June 21, 2022
Sometimes we encounter information where directions instruct us to drain the compressor being removed from a system and measure the amount of oil that drains out. Then the next step is to subtract this number from the number of ounces that are supposed to be in the shipped replacement compressor.Read Article >

OEM oil capacity information
June 7, 2022
If you are installing an OEM replacement compressor in this example then it "should" contain 4.5 ounces of oil but if the compressor is not drained and the oil measured, the amount will not be known for sure. Also, if an aftermarket compressor is being installed, there is no standard that exists in the industry regarding the amount of oil that might be shipped in a replacement compressor. It might have no oil in it, a partial charge, or a full charge or even more than a full charge. To make matters worse, the OEM does not provide the total system capacity for this vehicle.Read Article >

Compressor lubrication tips
May 26, 2022
We will focus on lubrication information that is often encountered and how it can be interpreted incorrectly and result in the incorrect amount of oil being installed in a system.Read Article >

The desiccant myth
April 12, 2022
There is a myth that exists involving A/C service work and driers that seems to come up from time to time. I have encountered it when handling tech calls and have seen it come up in A/C forums. Read more to find out what it is.Read Article >

MACS 2023 Annual Training Event and Trade Show
April 7, 2022
MACS 2023 Annual Training Event is back on schedule for 2023! We will meet at the Gaylord Opryland Resort in Nashville, TN. February 2-4, 2023.Read Article >

No drier replacement, no compressor warranty!
April 6, 2022
Compressor manufacturers and parts distributors are adamant about driers being replaced when one of their compressors are installed. No drier replacement, no compressor warranty!Read Article >