English
Spanish
Temperature Matters
May 11, 2021
In addition to having good contact with connectors and getting accurate readings, there are some other important things to remember when doing temperature testing.Read Article >
Pass the temperature probe
May 4, 2021
The first step is to run the A/C system for a few minutes to let it stabilize. Then both probes should be connected side by side at both points that will be temperature tested in the system. For example, if you were testing the temperature drop across the condenser, this would need to be done on both the discharge line and the liquid line.Read Article >
Are you using the right tools for mobile A/C repair?
April 30, 2021
Your shop’s R-134a recovery/recycling/recharge (R/R/R) machine is in well-maintained condition. You have an R-1234yf gauge manifold set and an R-1234yf machine is on order; should arrive shortly.Read Article >
Contact counts in temperature testing
April 27, 2021
Proper contact is vital when connecting to A/C lines using the contact type temperature thermometers. To determine if I am getting good contact, I always like to place both connectors side by side on the same line and observe the temperature readings.Read Article >
MACS Mobile A/C Update Webinar Now Available On Demand
April 22, 2021
Every year the Mobile Air Climate Systems Association creates a special mobile A/C update clinic to help working technicians keep up with the rapidly changing mobile A/C service and repair...Read Article >
Tips for taking your mobile A/C system’s temperature
April 20, 2021
The contact type units do indeed have a high degree of accuracy, but precautions must be taken when using them (especially connecting to lines) to ensure the accuracy. Otherwise, it is possible to get readings that are easily 5° to 10° off and that can lead to an incorrect diagnosis.Read Article >
The pressure is on
April 19, 2021
By appearance, radiator caps seem to be a simple device. Yet, many technicians do not understand the cap’s real functionRead Article >
Temperature testing accuracy
April 13, 2021
Temperature readings can be easily used to determine if an orifice tube system might be undercharged, and they can also be used to charge an orifice tube system. But if the readings are not accurate, all they are going to do is cause you problems.Read Article >
Then things got complicated!
April 9, 2021
It was a 2013 Camaro. The complaint was poor cooling and the temp really would not change when you switched it from heat to cool. In diagnosing the job, the technician found the blend door was stuck to where it was blending heat. Until it was pulled out, the tech was not sure if it was a bad actuator or door.Read Article >
MACS upcoming training clinic, register today!
April 7, 2021
MACS will present Peter Orlando from CARQUEST Technical Institute for a Mobile A/C Service Essentials webinar. May 13Read Article >