By Elvis L. Hoffpauir, MACS president and COO We know that MACS members are the best of the best, the crème de la crème, go-to guys even for other A/C…
On Jul 14th, we discussed a lawsuit filed by Kevin O’Shea against Ford Motor Co, alleging that the company offered vehicles that “used an excessive amount of Nocolok flux in the design, manufacture and assembly of the air conditioner system evaporator cores, thereby creating an unreasonable health and safety risk …” According to the complaint, “exposure to and inhalation of the flux is extremely dangerous and can result in the development of several diseases and conditions.
Once again, the MACS office is beginning to receive calls about bad, contaminated or mislabled refrigerant. Some folks in theU.S.are receiving offers to purchase refrigerants that contain hydrocarbons (HC), notably under the designations HC-12a or similar names. All of these are listed as “unacceptable for use” on the EPAs companion page to the SNAP list.
The compressor is usually belt-driven by the engine crankshaft, and engages through an electromagnetic clutch.
In a scroll compressor, a scroll shaped “paddle” rotates inside a channel. By the offset of the paddle drive pin, the compressor drive shaft rotates the paddle in an orbiting or circular motion.
Rotary vane compressors contain a solid rotating cylinder called an impeller. The impeller is equipped with vanes that move in and out of slots in the impeller.
There are two types of piston compressors currently in use, the opposed axial type, (also often referred to as the swash plate type), and the single row axial or wobble-plate type. Depending on design, these compressors may contain five, six, seven, or ten pistons.
With either type of piston compressor, the pumping action of the pistons draws low
Soon temperatures will tumble, sweaters and jackets will come out and in order to be comfortable you’ll choose to turn on the heat inside your car. How does heated air get into your car?
Before draining the coolant, warm up the vehicle until the thermostat opens. Shut the engine off and place a pan under the radiator drain (the petcock) to catch the old coolant. Turning the petcock to loosen it will allow coolant to drain from the radiator. Once the coolant stops flowing, the pressure from the system has been released and you can remove the radiator cap to allow the coolant to drain completely.
A vehicle has many electrical circuits. For an electrical component to function properly, the electricity must return to the source through the ground side of the circuit. Ground paths are usually metal conductors such as wires or the vehicle frame, engine or body.
