By Elvis L. Hoffpauir, MACS president and COO We know that MACS members are the best of the best, the crème de la crème, go-to guys even for other A/C…
Once again, the MACS office is beginning to receive calls about bad, contaminated or mislabled refrigerant. Some folks in theU.S.are receiving offers to purchase refrigerants that contain hydrocarbons (HC), notably under the designations HC-12a or similar names. All of these are listed as “unacceptable for use” on the EPAs companion page to the SNAP list.
The compressor is usually belt-driven by the engine crankshaft, and engages through an electromagnetic clutch.
The Ford owners’ and enthusiasts forums on the Internet are awash in questions and discussions of Ford Motor Company’s recently-announced gradual changeover to a standard coolant for all their engines. Some owners are concerned that their favorite car company has crossed over to “the dark side” and adopted General Motors Dex-Cool, a sure sign of an automotive apocalypse.
In a scroll compressor, a scroll shaped “paddle” rotates inside a channel. By the offset of the paddle drive pin, the compressor drive shaft rotates the paddle in an orbiting or circular motion.
Rotary vane compressors contain a solid rotating cylinder called an impeller. The impeller is equipped with vanes that move in and out of slots in the impeller.
There are two types of piston compressors currently in use, the opposed axial type, (also often referred to as the swash plate type), and the single row axial or wobble-plate type. Depending on design, these compressors may contain five, six, seven, or ten pistons.
With either type of piston compressor, the pumping action of the pistons draws low
For reasons we just can’t figure out the number one internet search for mobile A/C components and the number one blog post consistently read is about the function of the system’s receiver drier.
The heater control valve (sometimes called the hot water valve) is used to control the rate at which coolant flows through the heater core. The valve is located on the…
Soon temperatures will tumble, sweaters and jackets will come out and in order to be comfortable you’ll choose to turn on the heat inside your car. How does heated air get into your car?
Before draining the coolant, warm up the vehicle until the thermostat opens. Shut the engine off and place a pan under the radiator drain (the petcock) to catch the old coolant. Turning the petcock to loosen it will allow coolant to drain from the radiator. Once the coolant stops flowing, the pressure from the system has been released and you can remove the radiator cap to allow the coolant to drain completely.
