Airworks will exhibit at MACS 2023 Trade Show
September 6, 2022
MACS is happy to welcome Airworks as a return exhibitor to MACS Training Event and Trade Show . The big event will take place February 2-4, 2023, at the Gaylord Opryland Resort and Convention Center in Nashville, TN. The Trade Show will be on Friday, February 3 from 10:30am-4pmRead Article >
MACS Welcomes Globus Electronics
September 2, 2022
MACS warmly welcomes Globus Electronics back to the MACS Trade Show from their native Brazil. Globus Electronics has been an active MACS member since 2009.Read Article >
Improving A/C cool down time
July 19, 2022
If there is an issue with an A/C system, then obviously that needs to be fixed and that will aid in cool down time. However, if a system is working properly and a customer is complaining, then the focus needs to shift toward educating the customer on steps they can take to improve cool down time.Read Article >
A/C not cooling fast enough
July 13, 2022
When a vehicle sits outside in direct sunlight, a tremendous amount of heat can build up inside. Even with relatively mild summer ambient temperatures (75° F to 80°F) vehicle interiors can easily reach temperatures of 125° F or more. Consider that this heat is not just in the air inside, but also in the seats, dashboard, floor board, roof, door panels, etc, (essentially the entire inside of the vehicle).Read Article >
Compressor lubrication tips
May 26, 2022
We will focus on lubrication information that is often encountered and how it can be interpreted incorrectly and result in the incorrect amount of oil being installed in a system.Read Article >
A new refrigerant for Trucks?
May 4, 2022
EPA has listed HFO-1234yf under the Significant New Alternatives Policy Program for Motor Vehicle Air Conditioning in Non-road Vehicles and Servicing Fittings for Small Refrigerant CansRead Article >
The desiccant myth
April 12, 2022
There is a myth that exists involving A/C service work and driers that seems to come up from time to time. I have encountered it when handling tech calls and have seen it come up in A/C forums. Read more to find out what it is.Read Article >
MACS 2023 Annual Training Event and Trade Show
April 7, 2022
MACS 2023 Annual Training Event is back on schedule for 2023! We will meet at the Gaylord Opryland Resort in Nashville, TN. February 2-4, 2023.Read Article >
No drier replacement, no compressor warranty!
April 6, 2022
Compressor manufacturers and parts distributors are adamant about driers being replaced when one of their compressors are installed. No drier replacement, no compressor warranty!Read Article >
Refrigerant supply, pricing and safety
March 8, 2022
What I'm hearing about refrigerant supply and pricing this year reminds me of a similar period in the mid-2000s. It was springtime, just before the start of A/C season. Supplies of R-134a were tight and the price had come close to tripling from the prior year.Read Article >
When you don’t know about clutch wires
December 27, 2021
The conversation involved a clutchless compressor unit. A CSR who had sold one to a shop contacted me and said his customer (who was both the shop owner and technician working on the car) had just called him. There was a concern that the compressor didn't have a clutch wire.Read Article >
The pulse width modulated duty cycle signal
December 7, 2021
Several years ago, when vehicles using these compressors were just starting to show up at shops for service with some regularity, we were searching to find some detailed information about their behavior to use in clinics. There was not a lot of it available, so we borrowed several vehicles and did some videos. The following are some clinic slides produced from one of those videos.Read Article >
