Focus on the condenser!
May 31, 2021
In last week's article, we focused on applying temperature testing to an evaporator in an orifice tube system. In it we illustrated how and why a low liquid level in the evaporator can cause a large temperature differential between the inlet and outlet. We also indicated how and why raising the liquid level will cause the temperature differential to decrease. Now it is time to focus on the condenser.Read Article >
Show me your MACS 609 card
May 26, 2021
When you purchase refrigerant in quantities of two pounds or more you must show your Section 609 card.If you are Section 609 certified through MACS between 1991 and May 2021...Read Article >
Temperature testing detective work: The search for a diagnosis
May 25, 2021
Last week we closed our blog post with a discussion about an orifice tube system which had an evaporator outlet temperature that was about 20° warmer than the inlet. We mentioned that this could be an indication of a restricted orifice tube or a refrigerant undercharge. In applying this to diagnostics, it is important not only to understand what this represents, but also why.Read Article >
What is your temperature testing data telling you?
May 18, 2021
If air conditioning systems were transparent where we could see inside them, then diagnostics would be faster and easier. We could look at the systems and see things right away that affect system operation, like restrictions and liquid levels in evaporators and condensers.Read Article >
AIM: EPA’s HFC Authority Is On!
May 14, 2021
On December 27, 2020, President Trump signed into law the Consolidated Appropriations Act, which at $2.3 trillion is one of the largest spending bills in US history. It combines $600 billion in COVID relief with $1.4 trillion in twelve different appropriations bills. One of them is the AIM Act.Read Article >
Temperature Matters
May 11, 2021
In addition to having good contact with connectors and getting accurate readings, there are some other important things to remember when doing temperature testing.Read Article >
Pass the temperature probe
May 4, 2021
The first step is to run the A/C system for a few minutes to let it stabilize. Then both probes should be connected side by side at both points that will be temperature tested in the system. For example, if you were testing the temperature drop across the condenser, this would need to be done on both the discharge line and the liquid line.Read Article >
Are you using the right tools for mobile A/C repair?
April 30, 2021
Your shop’s R-134a recovery/recycling/recharge (R/R/R) machine is in well-maintained condition. You have an R-1234yf gauge manifold set and an R-1234yf machine is on order; should arrive shortly.Read Article >
Contact counts in temperature testing
April 27, 2021
Proper contact is vital when connecting to A/C lines using the contact type temperature thermometers. To determine if I am getting good contact, I always like to place both connectors side by side on the same line and observe the temperature readings.Read Article >
MACS Mobile A/C Update Webinar Now Available On Demand
April 22, 2021
Every year the Mobile Air Climate Systems Association creates a special mobile A/C update clinic to help working technicians keep up with the rapidly changing mobile A/C service and repair...Read Article >
Tips for taking your mobile A/C system’s temperature
April 20, 2021
The contact type units do indeed have a high degree of accuracy, but precautions must be taken when using them (especially connecting to lines) to ensure the accuracy. Otherwise, it is possible to get readings that are easily 5° to 10° off and that can lead to an incorrect diagnosis.Read Article >
The pressure is on
April 19, 2021
By appearance, radiator caps seem to be a simple device. Yet, many technicians do not understand the cap’s real functionRead Article >
